Whoops Bubba you are getting too far over your skis. I forgot about the M/T in the chop to hold the parallel guide. Whatever they are both small and quick M/Ts.
I'm not counting on it but I may finish this sucker before the weekend is over.
ken
Saturday, December 01, 2018
Fitting The Vise Backer Board
I've spend most of the day fitting the vise backer board. Next up one last M/T to chop in the slab and the vise backer. Then drilling the hole for the vise screw, and cutting the channel for the parallel guide. If things go faster than expected and my back isn't kvetching too much I may start on the chop before whisky time.
Whoops Bubba you are getting too far over your skis. I forgot about the M/T in the chop to hold the parallel guide. Whatever they are both small and quick M/Ts.
I'm not counting on it but I may finish this sucker before the weekend is over.
ken
Whoops Bubba you are getting too far over your skis. I forgot about the M/T in the chop to hold the parallel guide. Whatever they are both small and quick M/Ts.
I'm not counting on it but I may finish this sucker before the weekend is over.
ken
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment